What You Will Need to get Started:
1. You can view further pages on our website for all relevant information including modem parameters, network diagrams and service coverage.
2. Minimum System Requirements:
a) 1.8m dish (at minimum);
b) PLL LNB (3.6 to 4.2 Ghz frequency range); (PLL is a must!)
c) 2 W BUC minimum, model NJT5667F or NJT5669F (also NJT5656 old and heavy unit could work). However, almost any BUC will work on our system as long as LO (Local Oscilator) is 4900MHZ; (Note: If you use a 5W BUC, you will need an external power supply for the BUC)
d) 30 m of cables; and
e) Linkstar Viasat DVB-S2A OR iDirect Evolution RCST (modem).
When you have your equipment ready Fill out a pre-commissioning form!
3. Antenna Pointing:
For Linkstar S2A modems
Point to AMC12/NSS10 Satellite – linear at 37.5°W
Use horizontal receive
RF Frequency: 4025 MHz
(L-Band Frequency: 1125 MHz)
Polarization: Horizontal
Transponder: 17
Symbol rate: 4500 ks
DVB-S2
You need to telnet into the Linkstar S2A RCST with a cross over cable using the default IP address, and enter the following commands exactly as you see them:(PLEASE NOTE THE NEW PARAMETER “DVB” THAT NEEDS TO BE CHECKED BEFORE ATTEMPTING TO POINT THE ANTENNA)
save -f 1125000
save -s 4500000
save -c 0×1029
save -pcr 0×365
save -pop 0x011e0001
save -o 1 (Note: Use save -o 2 if using an external power supply for BUC)
save -t -30
save -lnbv 18
save -dvb 1 [NOTE: This will make your modem DVBS2]
hw
After you enter the command “hw”, the modem will reboot, and once it comes back on line, the sat “LED” should start blinking (providing you are locked on NSS-10). At this point, give us a call at NOC (905)573-9449.
You can also download our TuningGuide software to assist in pointing your antenna for the best receive ESNo.
Using our additional software, ConfigCreator, modem configuration files can be generated for use with TuningGuide.
For iDirect Evolution
Point to AMC12/NSS10 Satellite – linear at 37.5°W
Use horizontal receive
RF Frequency: 4036.5 MHz
(L-Band Frequency: 1113.5 MHz)
Polarization: Horizontal
Transponder: EAH17
DVB-S2
4. Fees and Charges:
The Customer agrees that the Service is provided to him subject to the Customer’s timely payment of all monthly issued invoices.
5. Acceptable Forms of Payment:
The Operator must be paid in full via one of the following payment forms:
a) direct wire into Canada; or
b) deposit into local Bank in Nigeria; or
c) payment via Western Union; or
d) payment via a Money Gram.
6. Software/Network Configuration:
Please see our support pages for software and network configurations as well as modem parameters.
7. NOC Support:
Please see our support page located at www.juch-tech.com/support and under the support section. If you have any other inquiries please contact XICOM Technical Support at (905) 573-9449 or email noc@xicom.ca.
